Ready Remote 24927 Guía de instalación descargar pdf (Pagina 25)

Crimp your spade connector to the hood pin wire, and run the wire

into the vehicle's passenger compartment through a factory rubber

grommet (at the same time you might want to run the Tachometer

Input wire and Horn output wire from the Optional Harness

through the fire wall as you may need to connect them using the

following steps).

Using a sharp, pointed object, poke a hole into the grommet

(being careful not to damage any existing wires in the grommet)

and attach the wire to the object with electrical tape. Pull the

wire through the grommet, taking extra care to keep the wire away

from any moving parts or anything that will generate extreme

heat.

An alternative to this method would be to find a spot on the fire-

wall with sufficient clearance on both sides and drill an access

hole through the firewall. Take note of what is directly on the

other side of where you are drilling as to not puncture brake cylin-

ders, computers, etc. Once the wire is run into the vehicle and

secured from any moving parts, solder the wire to the VIOLET wire

of the 6-pin harness and wrap the connection with electrical tape.

WARNING! This wire MUST be connected. Do not

use the vehicle until you confirm the operation

of the hood pin shutdown. Improper operation

could result in serious injury or death.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 94 95

Sin comentarios

Ready Remote 24927 Guía de instalación Pagina 25