Ready Remote 24927 Guía de instalación descargar pdf (Pagina 33)

Type D: Adding one or more aftermarket actuators

In order for this system to control one or more aftermarket actu-

ators, a DEI 451M (not included) or two relays are required.

Vehicles without factory power door locks require the installation

of one actuator per door. This requires mounting the door lock

actuator inside the door.

Other vehicles may only require one actuator installed in the dri-

ver's door, if all door locks are operated when the driver's lock is

used. This type of installation is required to operate factory lock

systems in Volvo (except 850), SAAB, and most Kia, Mazda, Isuzu

and Subaru models. The fuse used on 12 volt inputs should be

7.5A per motor installed in the vehicle.

Note: Directed Electronics offers actuators available at larger retail

chain stores. You will find them in the installation bay (P/N:524T).

Important! Do not connect the outputs of the alarm directly

to the actuator.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 94 95

Sin comentarios

Ready Remote 24927 Guía de instalación Pagina 33