Ready Remote 24927 Guía de instalación descargar pdf (Pagina 39)

Determining the Proper Resistor Values

To determine the resistor values, the door lock switch/key cylin-

der must be isolated from the factory door lock system. For all

testing, use a calibrated digital multimeter that is set to ohms.

1. Cut the output wire from the door switch/key cyclinder in

half.

2. Test with the meter from the switch side of the cut door

switch/key cylinder wire to a reliable constant (+)12V source.

Some good constant (+) 12V references are the power input

source to the door lock switch/key cylinder, the ignition

switch power wire, or the (+) terminal battery.

3. Operate the door lock switch/key cylinder in both directions

to determine the resistor values. If the multimeter displays

zero resistance in one direction, no resistor is needed for

that direction.

4. Once the resistor value(s) is determined, refer to the wiring

diagram for proper wiring.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 94 95

Sin comentarios

Ready Remote 24927 Guía de instalación Pagina 39