Ready Remote 24927 Guía de instalación descargar pdf (Pagina 49)

Step 7, Programming

Programming transmitters

Your system can learn up to 4 transmitters. The following proce-

dure will show you how to add additional transmitters or replace

old ones. The remotes in this package have already been

programmed to the control module.

Each transmitter can be programmed one button at a time or you

can use an auto learn procedure that learns the intended factory

configuration. Learning one button at a time is generally only

used when using one transmitter to control two different cars.

Being able to program functions to different channels on each

transmitters prevents multiple cars from responding simultane-

ously.

1. Turn the ignition ON

2. Press/release the Momentary switch the same number of

times as the desired transmitter learn step number, and

then Press/HOLD.

3. After holding the Momentary switch for 2 seconds the

LED will begin to flash to indicate the number of the

accessed transmitter learn step.

4. Press the transmitter button that you want to control

the function assigned to that channel. The Horn/Siren

will emit a long chirp.

Note: For transmitter learn Step #1, you must press the “*” but-

ton on the transmitter. This will automatically program the trans-

mitter buttons to the default function configuration. See the

transmitter button auto learn chart for the assignment functions.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 94 95

Sin comentarios

Ready Remote 24927 Guía de instalación Pagina 49